Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2012-12-14	AIR FILTER.	LUKE HARRISON	$16.25
2012-12-12	CUSTOMER REQUEST TO HAVE ENGINE INSTALLED.	LUKE HARRISON	$866.72
2012-12-17	LIGHT BULB REPLACEMENT (2) LEFT REAR TURN SIGNAL, THIRD BRAKE LIGHT.	MYLES HOLYOAK	$21.30
2012-11-26	PLEASE ASSEMBLE COMPLETE ENGINE. CUMMINS 5.9L CUMMINS COMPLETE LONG BLOCK. WARRANTY DOES NOT COVER TOWING, LABOR TO REMOVE AND REPLACE ENGINE, AND DOES NOT COVER ANY PART FAILURE. TECHNICIAN FOUND A SLIGHT GROOVE IN THE CRANKSHAFT SEALING AREA AND RECOMMENDS INSTALL A KWIK SLEEVE AND OVER SIZED SEAL.	LUKE HARRISON	$1,070.59
2012-12-13	PLEASE INSTALL NEW FUEL FILTER DURING ENGINE INSTALL.	MYLES HOLYOAK	$40.14
2012-12-14	PLEASE REMOVE THE PASSENGER SIDE FRONT DOOR PANEL TO INSTALL CUSTOMER SUPPLIED MIRROR.	LUKE HARRISON	$42.09
2012-12-17	STATE - SAFETY INSPECTION TEST (ONLY)*	LUKE HARRISON	$17.00
2012-12-14	TECHNICIAN COMPLETED THE ENGINE BUILD AND INSTALL AND FOUND THE ENGINE OIL PRESSURE GAUGE TO BE READING VERY LOW. TECHNICIAN INSTALLED A MANUAL PRESSURE GAUGE ON THE BLOCK TO VERIFY PROPER ENGINE OIL PRESSURE IN THE ENGINE. TECHNICIAN FOUND THE OIL PRESSURE ON A MANUAL GAUGE TO BE COMPLETELY WITH-IN SPECIFICATION AND RECOMMENDS PERFORM AN ELECTRICAL DIAGNOSIS. TECHNICIAN FOUND THE OIL PRESSURE SENDING UNIT TO BE DAMAGED AND SHORTED. (IT LOOKS LIKE THE SENSOR WAS LEFT IN DURING MACHINE WORK). TECHNICIAN RECOMMENDS REPLACE THE SENDING UNIT.	MYLES HOLYOAK	$84.17
2012-12-14	TECHNICIAN FOUND THE CAMSHAFT POSITION SENSOR TO BE DAMAGED AND RECOMMENDS REPLACE. PLEASE INSTALL KNOWN GOOD USED SENSOR.	MYLES HOLYOAK	$0.00
Sub-total			$2,158.25
Hazardous Materials Disposal			$48.26
Shop Supplies			$49.11
Sub-total			$2,255.62
Tax ($6.85%)			$146.68
Total			$2,402.30

* Items marked with a red asterisk are not taxed.

Payments

Total Payments To Date			$2,402.30
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap