Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2014-02-17	COURTESY INSPECTION (FREE)technician found that the front marker lights out, no oil on dipstick, small tick from right exhaust manifold. p/s hoses saturated, all 3 serpentine belts cracked, timing belt replacement also, battery is from 2010, light corrosion at terminals, some slight play at the front wheel bearings. front brakes at 8 and rears 4 through peep hole, abs light is on and code 17 g sensor.	JACOB KAUFFMAN	$0.00
2014-02-21	DIAG. LEVEL 1 ELECTRICAL DIAGNOSTIC WORKSHEET abs light is on. Technician inspected and tested the fuses and circuits for any breaks/shorts. Technician found that the fuses and circuits were good. Tested at the g sensor(lateral accelerometer) for power and ground. There was not getting voltage through the internal circuit board. Through researching had found that some other sensors would loose contact internally and with pressure on the bottom it would work. Technician found that when presseure was applied on the bottom of the sensor the voltage appeared and the various voltages occured when the different angles were performed as reseaching had demonstrated. Placed a washer below the sensor, bolted it down and is working properly.	JACOB KAUFFMAN	$164.16
2014-02-21	FLEET RATE BULB REPLACEMENT center brake light	JACOB KAUFFMAN	$7.99
2014-02-21	FLEET RATE BULB REPLACEMENT right front marker	JACOB KAUFFMAN	$7.99
2014-02-21	FLEET RATE BULB REPLACEMENT. left front marker	JACOB KAUFFMAN	$7.99
2014-02-21	FLEET RATE CAR OIL CHANGE	JACOB KAUFFMAN	$20.48
2014-02-21	FLEET RATE SAFETY AND EMISSIONS*	JACOB KAUFFMAN	$30.00
Sub-total			$238.61
Total			$238.61

* Items marked with a red asterisk are not taxed.

Payments

Total Payments To Date			$238.61
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap