Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2017-12-05	ALIGNMENT - FRONT END	RUSSELL HUDSON	$69.99
2017-12-05	CUSTOMER RETURNED ASKING US TO RE TRIM THE FENDERS FOR TIRE CLEARANCE, TECHNICIAN CHECKED AND FOUND THE TRUCK HAS BEEN LOWERED SINCE IT WAS HERE LAST, TECHNICIAN NOTED THE TRUCK HAS BEEN SET TOO LOW AND IS RESTING ON THE BUMP STOPS ON THE LOWER CONTROL ARM. TECHNICIAN ALSO NOTED THE RIGHT SIDE CV AXLE IS RUBBING ON THE LOWER SHOCK BOLT, AND THERE IS A NUT MISSING ON THE RIGHT SIDE LOWER CONTROL ARM BRACKET. TECHNICIAN ALSO NOTED THE REAR WHEEL SPEED SENSOR ON THE RIGHT SIDE IS DANGLING AND RESTING ON THE EXHAUST, THE FRONT TWO SENSORS ARE HANGING UNSECURED AS WELL. CUSTOMER WOULD LIKE TO SET CORRECT RIDE HEIGHT IN THE FRONT AND MEASURE REAR TO SEE IF ADJUSTMENTS WILL BE REQUIRED, REPAIR FRONT BRACKET AND ENSURE THE AXLE WILL CLEAR SHOCK BOLT, PROPERLY SECURE ALL WHEEL SPEED SENSORS, RE CHECK TORQUE ON REMAINING LIFT COMPONENTS. AND SEND OUT FOR ALIGNMENT. CUSTOMER DECIDED TO REMOVE THE 1 INCH BLOCK AND INSTALL A 2 INCH BLOCK TO ATTAIN LEVEL RIDE HEIGHT WITH THE FRONT.	TYLER SPANGLER	$176.76
Sub-total			$246.75
Shop Supplies			$13.57
Sub-total			$260.32
Total			$260.32

Payments

Total Payments To Date			$260.32
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap