Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2019-01-18	COURTESY INSPECTION (FREE)-TECH FOUND THE DRIVERS OUTER CV AXLE IS LEAKING GREASE DUE TO BEING SLIGHTLY TORN, TECH FOUND CODE P160C-GPCM CODE ENGINE CALIBRATION, BOTH BATTERIES TEST "REPLACE SOON" ON TEST, AND TEC FOUND THE HYDRO BOOST LINES ARE DRIPPING FLUID.	KYLE METCALF	$0.00
2019-01-18	CUSTOMER STATES THE CHECK ENGINE LIGHT IS ON, PLEASE CHECK AND ADVISE. TECHNICIAN FOUND CODE P160C FOR GLOW PLUG CONTROL MODULE FAULT. TECHNICIAN PERFORMED DIAGNOSIS ON CONTROL MODULE CIRCUITS TO VERIFY POWERS AND GROUNDS AND FOUND THEM TO BE PROPER. THE FUNCTION OF THE MODULE IS NOT CORRECT. TECHNICIAN RECOMMENDS PERFORM GPCM RE PROGRAMMING, RE CHECK OPERATION, AND TEST DRIVE TO RE CHECK. TECHNICIAN NOTED THE MODULE IS NOW OPERATING AS DESIGNED.	TREY GALE	$84.17
2019-01-18	FLEET RATE EMISSIONS.	TREY GALE	$20.00
Sub-total			$104.17
Shop Supplies			$573
Sub-total			$109.90
Total			$109.90

Payments

Total Payments To Date			$109.90
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap