Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2019-02-19	COURTESY INSPECTION (FREE) - TECHNICIAN NOTES, THE WIPER BLADES ARE SLIGHTLY STREAKY, THE RIGHT LICENSE PLATE LIGHT IS BURNT OUT, THE BRAKE FLUID IS VERY GREEN, THERE IS AN OIL LEAK COVERING THE BOTTOM OF THE ENGINE, THE AIR FILTER IS DIRTY, THERE IS MINOR PLAY IN THE LEFT LOWER BALL JOINT, THE FRONT DRIVE LINE IS MISSING, REAR DRIVE LINE U-JOINTS LOOK RUSTY, SHOCKS LOOK ORIGINAL AND ARE VERY RUSTY, THERE IS AN EXHAUST LEAK COMING FROM THE UP PIPES, THE FRONT AND REAR BRAKE PADS ARE AT 2/32" THE FUEL FILTER IS DUE BY THE MILES, THE FRONT AND REAR DIFFERENTIALS ARE LEAKING FROM THE COVERS, AND THE PASSENGER REAR VIEW MIRROR IS MISSING THE MIRROR. CUSTOMER HAS BEEN INFORMED AND HAS DECLINED FURTHER REPAIRS AT THIS TIME.	TYLER SPANGLER	$0.00
2019-02-19	CUSTOMER STATES, THE VEHICLE WON'T START UNLESS JUMP STARTED. ONCE IT IS JUMP STARTED IT WILL ONLY RUN FOR ABOUT 20 SECONDS AND DIE AGAIN. PLEASE CHECK AND ADVISE. TECHNICIAN NOTES, THE VEHICLE WAS 11 QUARTS LOW ON ENGINE OIL CAUSING THE HIGH PRESSURE OIL SYSTEM TO KILL THE VEHICLE ONCE IT STARTED. AFTER TOPPING OFF THE SYSTEM TECHNICIAN STARTED CHECKING PRESSURES WITH A SCAN TOOL AND FOUND THE INJECTION CONTROL PRESSURE SENSOR TO HAVE READINGS ALL OVER THE PLACE. AFTER VISUALLY INSPECTING THE SENSOR, IT IS LEAKING LARGE AMOUNTS OF OIL AS WELL. TECHNICIAN RECOMMENDS CHANGING THE SENSOR AND RECHECKING PRESSURES TO SEE IF WE NEED TO REPLACE THE INJECTOR PRESSURE REGULATOR AS WELL.	TYLER SPANGLER	$256.42
Sub-total			$256.42
Shop Supplies			$14.10
Sub-total			$270.52
Total			$270.52

Payments

Total Payments To Date			$270.52
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap