Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2019-12-02	COURTESY INSPECTION (FREE)	TYLER SPANGLER	$0.00
2019-12-02	CUSTOMER STATES THE BATTERIES ARE GOING DEAD WITHIN ABOUT TWO HOURS OF THE ENGINE BEING SHUT OFF, PLEASE CHECK AND ADVISE. TECHNICIAN CHECKED AND FOUND A PARASITIC DRAW OF ABOUT .5 AMPS. TECHNICIAN FOUND DRAW TO DROP OFF ONCE THE AFTERMARKET CB RADIO WAS DIS CONNECTED. AFTER TALKING TO THE CUSTOMER TECHNICIAN RE WIRED THE POWER SIGNALS TO THE RADIO TO AN IGNITION POWER ONLY SOURCE. TECHNICIAN RE TESTED AND FOUND THE DRAW TO BE GONE AT THIS TIME.	ADAM EGBERT	$270.75
2019-12-02	CUSTOMER STATES THE FOUR WHEEL DRIVE AUTOMATIC FUNCTION IS INOPERATIVE, PLEASE CHECK AND ADVISE. TECHNICIAN CHECKED AND FOUND THE FOUR WHEEL DRIVE AUTO FUNCTION TO BE INOPERATIVE. TECHNICIAN CHECKED AND FOUND THERE TO BE VACUUM FROM THE VACUUM PUMP AND GOOD VACUUM PRESENT UP TO THE VACUUM SWITCHING SOLENOID. THERE WAS NO VACUUM AFTER THE SOLENOID. TECHNICIAN VERIFIED PROPER SIGNALS TO THE SOLENOID, TECHNICIAN RECOMMENDS REPLACE THE SOLENOID AND RE CHECK THE SYSTEM. SYSTEM IS NOW WORKING AS DESIGNED.	ADAM EGBERT	$227.37
2019-12-02	CUSTOMER STATES THERE IS A LOUD NOISE COMING FROM WHAT SEEMS TO BE THE TURBO AREA UNDER ACCELERATION, PLEASE CHECK AND ADVISE. TECHNICIAN CHECKED AND FOUND THERE TO BE A LARGE EXHAUST LEAK ON THE LEFT SIDE MANIFOLD. TECHNICIAN RECOMMENDS REMOVE MANIFOLD TO INSPECT FOR FURTHER DAMAGE AND REPLACE MANIFOLD, BOLTS, AND GASKETS AS NECESSARY.	TYLER SPANGLER	$1,451.41
Sub-total			$1,949.53
Shop Supplies			$49.11
Sub-total			$1,998.64
Tax ($7.25%)			$141.34
Total			$2,139.98

Payments

Total Payments To Date			$2,139.98
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap