Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2019-12-23	COURTESY INSPECTION (FREE)	LUKE HARRISON	$0.00
2019-12-23	CUSTOMER STATES THE CHECK ENGINE LIGHT IS ON AND THERE IS A REALLY ROUGH IDLE, PLEASE CHECK AND ADVISE. TECHNICIAN FOUND THERE TO BE A DEAD MISFIRE ON CYLINDER #1. TECHNICIAN RAN A COMPRESSION TEST TO FIND COMPRESSION REALLY LOW. TECHNICIAN REMOVED VALVE COVER TO INSPECT AND FOUND THE INTAKE VALVE ON CYLINDER #1 TO BE NOT MOVING WHEN CRANKING THE ENGINE. TECHNICIAN INSPECTED THE PUSHROD AND ROCKER ASSEMBLY. TECHNICIAN BELIEVES THE ACTIVE LIFTER FOR CYLINDER #1 IS STUCK. PLEASE REMOVE THE CYLINDER HEAD TO INSPECT AND REPAIR.	ASHTON ORR	$1,587.37
2019-12-24	FLEET RATE - REMOVE SIDE STEPS.*	ASHTON ORR	$25.25
2019-12-24	FLEET RATE BULB REPLACEMENT - LEFT BRAKE LIGHT OUT.	ASHTON ORR	$7.99
2019-12-24	FLEET RATE BULB REPLACEMENT - RIGHT LICENSE PLATE LIGHT.	ASHTON ORR	$7.99
2019-12-24	PROMOTIONAL CLUSTER REBUILD	AUSTIN KALLUNKI	$149.99
2019-12-27	RADIO STICKER KIT.	RUSSELL HUDSON	$15.85
2019-12-23	STATE - EMISSIONS TEST (ONLY)*	LUKE HARRISON	$35.00
2019-12-24	TECHNICIAN FOUND THE TRANSMISSION LINE FROM TRANSMISSION TO AUXILIARY COOLER TO BE LEAKING, PLEASE REPLACE LINE.	ASHTON ORR	$121.34
2019-12-24	TECHNICIAN NOTES; RIGHT PLATE LIGHT OUT, LEFT BRAKE LIGHT OUT, CLUSTER IS NOT OPERATING, AIR FILTER IS A LITTLE DIRTY, FRONT BRAKES ARE AT 9/32", REAR BRAKES ARE AT 10/32", TRANSFER CASE REAR OUTPUT SEAL IS SEEPING, ENGINE OIL PAN AREA IS WET, RIGHT FRONT AXLE SEAL IS SEEPING.	ASHTON ORR	$0.00
2019-12-27	TIRE - TIRE PRESSURE MONITORING SENSOR. (PART ONLY) 315MHZ/433MHZ APPLICABLE TO MOST VEHICLES. MUST BE PROGRAMMED. BOTH LEFT SENORS.	ASHTON ORR	$120.77
Sub-total			$2,071.55
Shop Supplies			$49.11
Sub-total			$2,120.66
Total			$2,120.66

* Items marked with a red asterisk are not taxed.

Payments

Total Payments To Date			$0.00
Balance Remaining			$2,120.66

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap