Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2020-05-06	ALIGNMENT - FRONT END		$69.99
2020-05-06	CHEVROLET SILVERADO 2500HD FRONT END STEERING, PLEASE REPLACE THE IDLER ARM AND PITMAN ARM USING ECONOMY LINE PARTS. TECHNICIAN NOTED THE PLAY IS SEVERE AND RECOMMENDS RE CHECK AFTER REPLACING FOR OTHER POSSIBLE LOOSE PARTS.	TYLER SPANGLER	$376.74
2020-05-06	COURTESY INSPECTION (FREE)	DALLAS MCINTYRE	$0.00
2020-05-06	CUSTOMER STATES THE CHECK ENGINE LIGHT IS ON, PLEASE CHECK AND ADVISE. TECHNICIAN FOUND CODES; P0675 AND P0677 TECHNICIAN NOTED THIS IS MOST LIKELY A FAULT WITH CYLINDER #5 AND #7 GLOW PLUGS. TECHNICIAN RECOMMENDS REMOVE GLOW PLUGS TO TEST AND REPLACE IF VERIFIED FAULTY.	DALLAS MCINTYRE	$189.93
2020-05-06	FLEET RATE BULB REPLACEMENT - THIRD BRAKE LIGHT.	TYLER SPANGLER	$7.99
2020-05-11	PLEASE REMOVE BULL BAR.	TYLER SPANGLER	$26.75
2020-05-06	TECHNICIAN FOUND THE SERVICE AIR BAG SYSTEM LIGHT TO BE ON WITH CODE B0022, PLEASE CHECK AND ADVISE. TECHNICIAN CHECKED AND FOUND THE RIGHT SIDE SEAT BELT RETRACTOR PRE TENSIONER TO BE INTERNALLY SHORTED. PLEASE REPLACE AND RE CHECK.	DALLAS MCINTYRE	$289.16
2020-05-06	TECHNICIAN NOTED THIS TRUCK IS DELETED.	DALLAS MCINTYRE	$0.00
2020-05-06	TECHNICIAN NOTES; THIRD BRAKE LIGHT OUT, FRONT TIRES ARE BADLY CUPPED, IDLER AND PITMAN ARM ARE VERY LOOSE, FRONT BRAKE PADS ARE AT 5/32", REAR BRAKE PADS ARE AT 4/32", CHECK ENGINE LIGHT ON, SERVICE AIR BAG LIGHT ON, TRANSMISSION COOLER LINES IS SEEPING.	DALLAS MCINTYRE	$0.00
2020-05-06	TIRES - ROTATE AND CHECK TIRE PRESSURES	TYLER SPANGLER	$17.99
Discount (100.00%)			-17.9910.00
Sub-total			$960.56
Shop Supplies			$49.11
Sub-total			$1,009.67
Total			$1,009.67
Total Discount			$17.99

Payments

Total Payments To Date			$1,009.67
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap