Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2020-09-04	BRAKE FLUID CAP AND SEAL.	KYLE METCALF	$19.56
2020-09-02	COURTESY INSPECTION (FREE)	KYLE METCALF	$0.00
2020-09-02	FLEET RATE EMISSIONS.*	KYLE METCALF	$25.00
2020-09-04	FLEET RATE STANDARD BRAKE PAD INSTALL. REAR BRAKE PADS ARE AT 1/32".	TREY GALE	$129.22
2020-09-04	TECHNICIAN FOUND THE PTO COVERS BOTH TO BE LEAKING BADLY, TECHNICIAN NOTED ITS POSSIBLE THE TRANSMISSION PAN IS LEAKING AS WELL. TECHNICIAN RECOMMENDS FIRST RE SEAL THE PTO COVERS AND CLEAN UP TO RE CHECK FOR A TRANSMISSION PAN LEAK.	TREY GALE	$157.68
2020-09-04	TECHNICIAN FOUND THE TRANSFER CASE REAR OUTPUT SEAL TO BE LEAKING BADLY AND FLUID IS ALSO THROWING FROM THE SLIP YOKE. TECHNICIAN RECOMMENDS REPLACE REAR OUTPUT SEAL AND ADD SEALANT TO THE BACK OF THE SLIP YOKE.	TREY GALE	$152.86
2020-09-04	TECHNICIAN NOTES; BRAKE FLUID RESERVOIR CAP IS MISSING, FRONT TIRES ARE CUPPING, POWER STEERING FLUID IS A LITTLE LOW, FRONT BRAKE PADS ARE AT 6/32", REAR BRAKE PADS ARE AT 1/32", TIRE PRESSURE LIGHT IS ON, ALL FOUR BALL JOINTS HAVE SLIGHT PLAY, IDLER ARM AND PITMAN ARM HAVE SLIGHT PLAY, POWER STEERING LINE IS SEEPING, BACK OF THE ENGINE IS LEAKING OIL, FRONT DIFFERENTIAL HAS A SLIGHT SEEP, TRANSMISSION IS LEAKING FROM THE PTO COVERS AND FLUID PAN, TRANSFER CASE IS LEAKING FROM THE REAR OUTPUT AND SLIP YOKE ASSEMBLY, LOW COOLANT LIGHT FLICKERED ON FOR A MINUTE DURING TEST DRIVE BUT WENT OUT AND THERE WERE NO LEAKS AND THE COOLANT IS FULL.	KYLE METCALF	$0.00
Sub-total			$484.32
Shop Supplies			$31.48
Sub-total			$515.80
Total			$515.80

* Items marked with a red asterisk are not taxed.

Payments

Total Payments To Date			$515.80
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap