Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2020-10-23	CUSTOMER STATES, THE CHECK ENGINE LIGHT IS ON AND THE SERVICE STABILITRAC MESSAGE IS COMING ON THE DASH. PLEASE CHECK AND ADVISE. TECHNICIAN NOTES, THE CHECK ENGINE LIGHT HAD THREE CODES STORED. THE FIRST TWO WERE P0171 AND P0174 FOR FUEL TRIM SYSTEM LEAN ON BANK 1 AND 2. (SEE SEPERATE JOB FOR INFORMATION ON THE THIRD CODE). TECHNICIAN CLEARED THE CHECK ENGINE LIGHT AND THOSE TWO CODES CAME BACK. THE VEHICLE ALSO HAS A ROUGH IDLE THAT FEELS LIKE THE INJECTOR ISN'T FUELING PROPERLY. TECHNICIAN RECOMMENDS REMOVING ALL 8 FUEL INJECTORS TO CLEAN AND RESEAL THEM. AFTER DOING THIS SERVICE THE ROUGH IDLE ISSUE HAS GONE AWAY AND THE CODES HAVE NOT RETURNED.	ASHTON ORR	$166.61
2020-11-06	TECHNICIAN NOTES, THE THIRD CHECK ENGINE LIGHT IS A P0573 FOR BRAKE SWITCH CIRCUIT 1 HIGH VOLTAGE. TECHNICIAN ALSO NOTICED THE CRUISE CONTROL DOESN'T WORK. THE CODE RETURNED AFTER CLEARING IT AS WELL. TECHNICIAN RECOMMENDS REPLACING THE BRAKE SWITCH AND RECHECKING FOR OTHER POSSIBLE ISSUES, IF THE CODE RETURNS.	ASHTON ORR	$78.77
2020-11-06	TECHNICIAN NOTES, WE WERE UNABLE TO COMMUNICATE WITH THE VEHICLE USING A SCAN TOOL. WE CHECKED FUSES AND FOUND IT WAS BLOWN. WE REPLACED IT AND WERE ABLE TO USE THE SCAN TOOL FOR ONLY A COUPLE OF MINUITES BEFORE THE FUSE BLEW AGAIN. TECHNICIAN RECOMMENDS LOOKING INTO THIS ISSUE. UPON DIAGNOSIS TECHNICIAN TRACED THE WIRING BACK TO A POINT WHERE IT WAS PINCHED. WE REROUTED THE WIRE AND HAVEN'T HAD ANY FURTHER ISSUES WITH BLOWING FUSES.	ASHTON ORR	$89.17
Sub-total			$334.55
Shop Supplies			$21.75
Sub-total			$356.30
Total			$356.30

Payments

Total Payments To Date			$356.30
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap