Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2020-11-23	CUSTOMER STATES THERE IS A FUEL LEAK PRESENT, PLEASE CHECK AND ADVISE. TECHNICIAN CHECKED AND FOUND THERE TO BE FUEL LEAKING FROM THE FACTORY LOCATION HIGH PRESSURE PUMP. TECHNICIAN NOTED THIS IS A DUAL PUMP SYSTEM AS WELL AS A COMPOUND TURBO SET UP. TECHNICIAN RECOMMENDS DIS ASSEMBLE TO GAIN ACCESS TO THE PUMP AND INSPECT WITH INTENT TO REPLACE. TECHNICIAN REMOVED THE HIGH PRESSURE CP3 PUMP AND FOUND THE PLUG ON THE BOTTOM SIDE HAS BLOWN OUT AND THERE IS A LARGE AMOUNT OF METAL MATERIAL UNDER THE PUMP. TECHNICIAN STATES A FAILURE OF THIS NATURE IS KNOWN TO CAUSE METAL DEBRIS TO CONTAMINATE THE ENTIRE FUEL SYSTEM. TECHNICIAN RECOMMENDS REMOVE INJECTORS AND SEND OUT FOR TESTING, AND REMOVE SECOND CP3 PUMP TO SEND OUT FOR TESTING. PLEASE DRAIN THE FUEL TANK, FLUSH OUT FUEL LINES, AND REPLACE FUEL FILTERS. INJECTOR TEST RESULTS CAME BACK WITH FAILURE DUE TO LOW/NO PRIMARY FLOW AS A RESULT OF METAL IN THE SYSTEM, PLEASE REPLACE ALL EIGHT INJECTORS. SECOND CP3 PUMP WAS CLEANED OUT AND TESTED GOOD. PLEASE REPLACE THE FUEL FILTERS A SECOND TIME AFTER DRIVING ROUGHLY 100 MILES TO ENSURE THE SYSTEM IS CLEAN. THIS REPAIR WILL CARRY A 12 MONTH WORKMANSHIP ONLY WARRANTY DUE TO THE AFTERMARKET PERFORMANCE MODIFICATIONS, PARTS MAY BE EXCLUDED FROM WARRANTY.	TYLER SPANGLER	$6,836.92
2020-12-17	UPON COMPLETION OF FUEL INJECTION SYSTEM REPAIRS TECHNICIAN FOUND A DRIPPING LEAK AT THE FUEL TANK AFTER DRIVING A FEW MINUTES. TECHNICIAN FOUND A BROKEN CLAMP ON TOP OF THE FUEL TANK NEAR THE SENDING UNIT. PLEASE REPAIR.	TYLER SPANGLER	$90.75
Sub-total			$6,927.67
Shop Supplies			$49.11
Sub-total			$6,976.78
FUEL			$80.00
Total			$7,056.78

Payments

Total Payments To Date			$7,056.78
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap