Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2020-12-09	AIR FILTER CLEAN AND RE-CHARGE SERVICE - K&N	AUSTIN EASTMAN	$19.99
2020-12-09	BG - FLUSH - BRAKE	AUSTIN EASTMAN	$84.99
2020-12-09	BG - OIL CHANGE - BETTER (INCLUDES BG SYNTHETIC ADDITIVE) RECOMMENDED SERVICE INTERVAL IS 5,000 MILES. PRICE DISPLAYED IS UP TO 5 QUARTS.	AUSTIN EASTMAN	$59.99
2020-12-07	COURTESY INSPECTION (FREE) TECHNICIAN NOTES; BOTH PLATE LIGHTS OUT, ENGINE OIL IS DUE FOR SERVICE BY OUR RECORDS, BRAKE FLUID IS DUE FOR SERVICE, OIL SEEP FROM FRONT AND REAR OF ENGINE PRESENT, AIR FILTER IS DIRTY AND CLEANABLE, SLIGHT POP IN DRIVERS SIDE INNER TIE ROD, FRONT STRUTS ARE STARTING TO SEEP, FRONT BRAKE PADS ARE AT 7/32", REAR BRAKE SHOES REQUIRE DIS ASSEMBLY TO INSPECT, FRONT DIFFERENTIAL ACTUATOR IS SEEPING, FRONT DIFFERENTIAL FLUID IS DARK, TRANSFER CASE FLUID IS GETTING DARK, ABS LIGHT IS CURRENTLY ON.	AUSTIN EASTMAN	$0.00
2020-12-07	CUSTOMER STATES THE CHECK ENGINE LIGHT IS ON, PLEASE CHECK AND ADVISE. TECHNICIAN FOUND CODE P0032 FOR A BANK 1 SENSOR 1 OXYGEN SENSOR. TECHNICIAN BEGAN TESTING THE CIRCUITS AND FOUND A POOR GROUND SIGNAL TO THE HEATER CIRCUIT. AFTER FURTHER INSPECTION TECHNICIAN FOUND THERE TO BE A BAD GROUND CONNECTION ON THE DRIVERS SIDE OF THE INTAKE MANIFOLD. TECHNICIAN NOTED THIS COULD BE THE REASON FOR THE FAULT CODE AS ITS THE GROUND FOR THE CIRCUIT. TECHNICIAN RECOMMENDS CLEAN AND PROPERLY SECURE GROUND, CLEAR CODES, AND TEST DRIVE TO RE CHECK AND MONITOR.	AUSTIN EASTMAN	$102.17
2020-12-09	NON SYNTHETIC FRONT DIFFERENTIAL SERVICE.	AUSTIN EASTMAN	$83.39
2020-12-09	TRANSFER CASE SERVICE (NON SYNTHETIC)	AUSTIN EASTMAN	$70.47
Sub-total			$420.99
Shop Supplies			$27.36
Sub-total			$448.35
Tax ($7.25%)			$30.52
Total			$478.87

Payments

Total Payments To Date			$478.87
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap