Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2021-03-12	CUSTOMER STATES, THE CHECK ENGINE LIGHT IS ON. PLEASE CHECK AND ADVISE. TECHNICIAN NOTES, THE CODES STORED WERE P2563 AND P003A BOTH TURBO RELATED CODES. WE VISUALLY CHECKED THE ELECTRICAL GOING TO THE TURBO AND FOUND NO ISSUES. WE REMOVED THE VEIN POSITION SENSOR AND VERIFIED IT IS ACTUATING PROPERLY WITH MANUAL OPERATION. TECHNICIAN RECOMMENDS REMOVING THE TURBO TO BE CLEANED AND INSPECTED. UPON REMOVAL OF THE TURBO TECHNICAIN HAD MULTIPUL UP PIPE BOLTS THAT WERE SEVERLY RUSTED IN PLACE BREAK OFF IN THE EXHAUST MANIFOLDS, AS WELL AS ONE EXHAUST MANIFOLD STUD BREAK AND MULTIPUL EXHAUST MANIFOLD NUTS ROUNDED OUT. THERE WERE ALSO TWO CLAMPS TO RUSTED TO REMOVE THE NUTS. TECHNICIAN RECOMMENDS REPLACING BOTH EXHAUST MANIFOLDS AND REPLACING THE BROKEN BOLTS, STUD, AND ROUNDED NUTS IN ADDITON TO THE TWO CLAMPS. UPON DISASSEMBLY OF THE TURBO THERE WAS BUILD UP CAUSING THE UNISON RING TO SEIZE, THERE IS NO MECHANICAL DAMAGE TO THE TURBO INTERNALLY AND THE TURBO WILL BE CLEANED BEFORE REINSTALLATION.	ADAM EGBERT	$2,615.74
2021-03-22	TECHNICIAN NOTES, WHILE TEST DRIVING THE VEHICLE THE SERVICE BRAKE SYSTEM MESSAGE CAME ON THE DASH. THE CUSTOMER WOULD LIKE US TO LOOK INTO THIS ISSUE. PLEASE CHECK AND ADVISE. TECHNICIAN NOTES, WE CHECKED FOR STORED CODES IN THE SYSTEM AND FOUND NO CODES STORED. WE THEN STARTED CHECKING THE WIRING GOING TO THE BRAKE MASTER CYLINDER AND FOUND THE WIRING LOOKED GOOD, BUT THE BRAKE FLUID LEVEL SENSOR WAS BROKEN WHEN WE REMOVED IT TO INSPECT. TECHNICAIN RECOMMENDS REPLACING THE BRAKE FLUID LEVEL SENSOR AND RECHECKING FOR OTHER ISSUES IF THE MESSAGE RETURNS.	LUKE HARRISON	$110.93
Sub-total			$2,726.67
Shop Supplies			$49.11
Sub-total			$2,775.78
Total			$2,775.78

Payments

Total Payments To Date			$2,775.78
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap