Not yet Run

Print Quote Print RO Print Invoice

Images

Jobs

Start Date	Description	Technician	Amount
2021-08-13	AIR FILTER CLEAN AND RE-CHARGE SERVICE - K&N	JONI WALKER	$19.99
2021-08-11	COURTESY INSPECTION (FREE) - TECHNICIAN NOTES, THE UPPER AND LOWER VALVE COVERS HAVE A MINOR SEEP, THE TRANSMISSION PAN HAS A MINOR SEEP, THE FRONT TIMING COVER HAS A MINOR SEEP, THE TRANSMISSION LINES HAVE A MINOR SEEP, THE AIR FILTER IS VERY DIRTY, THE BATTERY TERMINALS HAVE SOME CORROSION, THE FRONT AND REAR BRAKE PADS ARE AT 10/32", AND THE FUEL FILTER IS DUE BY THE MILES UNLESS ALREADY UP TO DATE.	JONI WALKER	$0.00
2021-08-11	CUSTOMER STATES, THERE IS A PARASITIC DRAW ON THE VEHICLE. THEY WERE TOLD BY ANOTHER SHOP THE INSTRUMENT CLUSTER IS THE CAUSE. PLEASE CHECK AND ADVISE. TECHNICIAN NOTES, WE STARTED WITH HOOKING UP A MULTIMETER TO MONITOR THE DRAW ON THE BATTERY. WE FOUND THERE IS LESS THAN A QUARTER AMP DRAW ON THE SYSTEM WHICH IS WITHIN SPEC. WE CHECKED THE FUSES IN THE FUSE BLOCK FOR POTENTIAL BLOWN FUSES THAT WOULD BE RELATED TO THE DRAW ON THE SYSTEM AND FOUND ALL THE FUSES CHECKED OUT NORMAL. WE TEST DROVE THE VEHICLE AND RETESTED AFTER TO FIND THERE IS STILL LESS THAN A QUARTER AMP DRAW ON THE SYSTEM. TECHNICIAN ALSO NOTED THE CHARGE WIRE COMING FROM THE ALTERNATOR TO THE DRIVERS SIDE BATTERY HAS CORROSION, WE HAVE SEEN IN THE PAST INTERMITANT PROBLEMS WITH THIS CHARGE WIRE COMING FROM THE ALTERNATOR. TECHNICIAN RECOMMENDS REDOING THE BATTERY TERMINAL AND THAT CONNECTION FOR THE CHARGE WIRE, AS A POSSIBLE CAUSE OF THE BATTERY NOT GETTING CHARGED UNTIL THE VEHICLE IS SITTING AND DRAINING THE PASSENGER SIDE BATTERY.	RUSSELL HUDSON	$188.87
Sub-total			$208.86
Shop Supplies			$835
Sub-total			$217.21
Tax ($7.25%)			$15.14
Total			$232.35

Payments

Total Payments To Date			$232.35
Balance Remaining			$0.00

View all Payments for this Invoice

KPI's

You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near '' at line 1You have an error in your SQL syntax; check the manual that corresponds to your MariaDB server version for the right syntax to use near 'and c.CustomerID=v.CustomerID and v.VehicleID=i.VehicleID and i.InvoiceID = ...' at line 1

KPI	Target	Actual	Gap