Absolute Car Care - Job 121468

- Welcome

Logout

Job #121468 for IDRIVE UTAH (Angela Pierce)
2006 Ford F-250
Invoice #21227

Technician:
Concern:	TECHNICIAN FOUND THE ENGINE TO HAVE A VERY LONG CRANK TO START WHEN THE TRUCK HAS SAT OVER NIGHT, PLEASE CHECK AND ADVISE. TECHNICIAN TEST DROVE AND FOUND THE LONG CRANK TO START TO BE ALMOST A NO START AFTER DRIVING A PERIOD OF ABOUT TWENTY MILES OR MORE. TECHNICIAN BEGAN DIAGNOSIS ON SYSTEM TO FIND THE INJECTOR PRESSURE REGULATOR (IPR) TO BE SHORTED AND CAN NOT MANUALLY SHUT SOLENOID TO AIR CHECK THE OIL PRESSURE SYSTEM. TECHNICIAN REMOVED THE IPR AND FOUND THERE TO BE METAL IN THE SCREEN. TECHNICIAN NOTES ANY METAL PRESENT IN THE SCREEN INDICATES A FAULT IN THE HIGH PRESSURE OIL PUMP (HPOP). TECHNICIAN IS UNABLE TO VERIFY FUNCTION OF THE REMAINING PARTS OF THE HIGH PRESSURE OIL SYSTEM UNTIL THE IPR HAS BEEN REPAIRED. TECHNICIAN NOTES THERE IS A POSSIBILITY OF FURTHER OIL SYSTEM LEAKS. TECHNICIAN ALSO NOTED THE FRONT OF THE INTAKE MANIFOLD IS LEAKING ANTIFREEZE. TECHNICIAN FIRST INSTALLED A USED KNOWN GOOD IPR TO FURTHER DIAGNOSE THE REMAINING PARTS OF THE HIGH PRESSURE OIL SYSTEM. TECHNICIAN FOUND LEAKS AT BOTH CYLINDER BANKS FROM THE BREACH PLUGS, TECHNICIAN REPLACED BREACH PLUGS WITH NEW UPDATED PARTS AND RE CHECKED TO FIND THE HIGH PRESSURE OIL SYSTEM TO BE OPERATING AS DESIGNED. TECHNICIAN ADVISED CUSTOMER OF REPLACING THE HPOP, AND INSTALLING A NEW IPR. CUSTOMER WOULD LIKE US TO LEAVE THE USED IPR IN PLACE, HOLD OFF ON INSTALLING THE HPOP AT THIS TIME, AND PROCEED WITH REPAIRING THE ANTIFREEZE LEAK FROM THE INTAKE AREA. UPON REMOVAL OF THE INTAKE MANIFOLD TO REPAIR THE ANTIFREEZE LEAK TECHNICIAN FOUND THE COOLING SYSTEM TO BE FULL OF WHAT APPEARS TO BE FUEL. TECHNICIAN STATES THIS IS TYPICALLY CAUSED BY CRACKED HEADS, TECHNICIAN RECOMMENDS REPLACE THE CYLINDER HEADS WITH UPDATED CASTING IMPROVED DESIGN.
Discount:	Percentage Dollar
Repair:
StartDate:
EndDate:
Tax this Job?

Parts and Labor

Description	Quantity	List	Total	Delete?
RADIATOR CAP	1.00	$14.19	$14.19	X
GREEN COOLANT 50/50 PRE MIX NUKOOL	3.00	$12.99	$38.97	X
INJECTOR RAIL PLU	2.00	$29.75	$59.50	X
LABOR	29.00	$95.00	$2,755.00	X
UPDATED CASTING CYLINDER HEADS THROUGH CLEGGS	1.00	$1,525.00	$1,525.00	X
KENDALL ENGINE OIL 15W-40	16.00	$5.99	$95.84	X
TOP END GASKET SET	1.00	$314.21	$314.21	X
HEAD GASKET	2.00	$85.86	$171.72	X
THERMOSTAT	1.00	$28.95	$28.95	X
HEAD BOLT SET LONG BOLTS	2.00	$94.23	$188.46	X
HEAD BOLT SET SHORT	2.00	$18.30	$36.60	X
WATER PUMP	1.00	$77.59	$77.59	X
RADIATOR	1.00	$269.50	$269.50	X
EGR PIGTAIL	1.00	$32.43	$32.43	X
Total			$5,607.96

Add a Part or Labor for this Job